Aquatic Life Aquariums

The biOrb bulb must be replaced with the correct Reef One 10 watt 12 volt bulb. Larger bulbs may kill the transformer and could have an adverse effect on the light unit and biOrb.

The acrylic stand fixes to the inside of the biOrb to provide a flat surface onto which a 50 watt heater can be fixed. Although designed for use in the biOrb, the heater stand can be used in most aquariums if desired.

A snap out section in the biOrb light unit provides a gap into which the lead from the heater can rest, keeping the lead tidy whilst allowing the light unit to remain snugly fitted in the top.

A partial water change of 30% should be carried out at the same time.

Contents:
Replacement filter cartridge
Algae cleaning cloth
Sachet of water preparation chemicals.

The cleaner pump makes partial water changes easy and effective with minimum effort. A couple of squeezes on the hand pump is all that is needed to get the pump working. Whilst emptying water from the aquarium the cleaner pump will also suck up dirt and debris from the bottom.

The cleaner pump can also be used to pump water back into the aquarium, eliminating the need to struggle with heavy buckets of water.

The rough side can also be used to remove lime scale build up from the base of the light unit.

Cleaning pads should only be used on the inside of the aquarium.

Reef One do not recommend using other algae pads on the biOrb as these may scratch the acrylic.

After a time the air stone can become blocked by calcification, especially in hard water areas, reducing the flow of air into the aquarium.

Replacing the air stone every few months will keep your aquarium bubbling away nicely.

Lid and base sets called Swap Tops are available in all eight colours so you can change the look of your biOrb whenever you want.

Colours